ATWINC1510 Firmware upgrade Guide

Description:

This Application uses the WiFi 7 click board (containing Microchip’s ATWINC1510-MR210PB IEEE 802.11 b/g/n module) to enable cloud connectivity. The application’s functioning requires the ATWINC1510 module to have firmware compatible with the WiFi software stack running on the ATSAME51 microcontroller(on SAM E51 Curiosity Nano Development Kit). To enable this compatibility, the ATWINC1510 module is updated with the firmware compatible with WiFi software running in the latest released demo.

Serial Bridge Application to upgrade ATWINC1510 Firmware

Complete the above highlighted step before proceeding further

Running the utility

Navigate to **“/wireless_wifi/utilities/wifi/winc"** and open command prompt.
The following command line will create and program a firmware image.

winc_flash_tool.cmd /p COM3 /d WINC1500/v 19.7.7 /e /x /i prog /w

NOTE : Respective device COM PORT should be selected in above command and all other serial terminal application should be closed
Wait till verify passed message comes up as shown below

Revision:

v1.6.0 - Updated steps to upgrade ATWINC1510 firmware. Regenerated and Tested the application.
v1.5.0 - Regenerated and tested application.
v1.4.0 - Released utility.