1.2.3.5 WBZ451 Curiosity

PL460-EK is connected to mikroBUS connector (J4) of WBZ451 Curiosity using a mikroBUS to Xplained Pro adapter (connections shown in the table below). A 15V DC jack must be plugged into PL460-EK in order to supply the power for PLC transmission. For more information about PL460-EK refer to its user guide.

Table 1-3. WBZ451 Curiosity mikroBUS and PL460-EK Connections
WBZ451 Curiosity Board PL460-EK Board
WBZ451 Pin mikroBUS Signal mikroBUS Pin Number Xplain Pro Pin Number Signal
PB1, AN5 AN 1 3 Supply Monitor
PB2 RST 2 7 NRST
PA9, SERCOM1_PAD2 CS 3 15 CS
PA8, SERCOM1_PAD1 SCK 4 18 SCK
PA10, SERCOM1_PAD3 MISO 5 17 MISO
PA7, SERCOM1_PAD0 MOSI 6 16 MOSI
+3.3V +3.3V 7 20 VCC
GND GND 8 11 STBY
GND GND 9 19 GND
+5V +5V 10 - -
PA13, SERCOM2_PAD0 SDA 11 8 ENABLE
PA14, SERCOM2_PAD1 SCL 12 12 TXEN
PA7, SERCOM1_PAD0 TX 13 - -
PA8, SERCOM1_PAD1 RX 14 - -
PA2 INT 15 9 EXTINT
PA2 PWM 16 - -
Figure 1-24. WBZ451Curiosity to PL460-EK Connection
Sleep Mode and Thermal Monitor functionalities are not used in this platform, as there are not enough GPIOs on mikroBUS connector to support them. Sleep Mode pin is set to GND in the adapter to avoid issues.
Figure 1-25. Sleep Mode and Thermal Monitor not used

WBZ451 has an ADC peripheral which is not currently supported by Pvdd Monitor service, thus this funcitonality is not added to this platform projects.

The micro-B USB connector (J7) of WBZ451 Curiosity can be used to:
  • Manage PLC PHY Tester Tool. UART baud-rate is configured at 115200 bps.
  • Flash/debug the WBZ451 device with the integrated programmer and debugger MPLAB PICkit On-Board 4 (PKOB4).

For more information about WBZ451 Curiosity refer to its user guide.

Note: WBZ451 radio is not compatible with currently supported modes on projects for RF215, so nodes of those platforms cannot be mixed in the same network.