SPI SST26 flash write read

This example demonstrates read and writing to SPI based SST26 flash

Description

This example uses the SPI peripheral library to write an array of values to the SST26 Flash and verify the value written by reading the values back and comparing it to the value written. The example application performs the SST26 write only once after a power on reset.

Downloading and building the application

To clone or download this application from Github, go to the main page of this repository and then click Clone button to clone this repository or download as zip file. This content can also be downloaded using content manager by following these instructions.

Path of the application within the repository is apps/spi/spi_sst26_write_read/firmware .

To build the application, refer to the following table and open the project using its IDE.

Setting up the hardware

The following table shows the target hardware for the application projects.

Setting up PIC32MZ W1 Curiosity Board

• Connect the Debug USB port on the board to the computer using a micro USB cable

Running the Application

1. Build and program the application project using its respective IDE
2. LED indicates the success or failure:
   • LED is turned ON when the value read from the Flash matched with the written value

Following table provides the LED name:

---