1.4.5 SAM E70 Xplained Ultra Evaluation Kit: Building and Running the QSPI Flash Bootloader applications

To clone or download this application from Github,go to the main page of this repository and then click Clone button to clone this repo or download as zip file. This content can also be download using content manager by following these instructions

Path of the application within the repository is apps/qspi_flash_bootloader/

To build the application, refer to the following table and open the project using its IDE.

• Connect the Debug USB port on the board to the computer using a micro USB cable

• Refer to UART Host Script Help for setting up the uart_host.py utility used to send the application binary from host PC

  • There will be no reset command sent from host after programming by default.

  • Reboot command has to be sent separately only after successful programming to trigger bootloader from programmer application

1. Open the bootloader project bootloader/firmware/sam_e70_xult.X in the IDE

2. Make sure that the app_programmer/firmware/sam_e70_xult.X is added as a loadable project to bootloader application

   • As the QSPI Flash memory may not have any valid binary required by bootloader for the first time, Adding the app_programmer as loadable allows MPLAB X to create a unified hex file and program both these applications in their respective memory locations based on their linker script configurations

   

3. Build and program the bootloader application using the IDE

4. Once programming is done bootloader starts execution and directly jumps to application space to run the programmer application

   • LED1 starts blinking every 500ms indicating that the programmer application is running

5. Open the programmer application project app_programmer/firmware/sam_e70_xult.X in the IDE

6. Update app_programmer/firmware/src/app.c to reduce the LED blink duration from 500ms to 100ms as below

   	APP_TIMER_DelayMs(100);

7. Clean and Build the project to generate the binary (Do not program the binary)

8. Run the uart_host.py from command prompt to program the updated programmer application binary in QSPI Flash memory

    python <harmony3_path>/bootloader_apps_serial_memory/tools/uart_host.py -v -i <COM PORT> -d same7x -a 0x402000 -f <harmony3_path>/bootloader_apps_serial_memory/apps/qspi_flash_bootloader/app_programmer/firmware/sam_e70_xult.X/dist/sam_e70_xult/production/sam_e70_xult.X.production.bin
   

9. Following snapshot shows output of successfully programming the programmer application

   • LED1 should still be blinking every 500ms

   

10. Run the uart_host.py from command prompt to send a Reboot command. This command Updates MetaData and triggers Bootloader to program the updated binary from QSPI Flash to Internal Flash

    python <harmony3_path>/bootloader_apps_serial_memory/tools/uart_host.py -v -i <COM PORT> -r
    

    

11. Once Firmware Update is successful LED1 should start blinking every 100ms indicating updated programmer application running

    • If there was any error you may need to power cycle the device to retry firmware upgrade

• To bootload any other application refer to Application Configurations

  • Note that this application should have programming capabilities to QSPI Flash Memory

• Once done repeat the applicable steps mentioned in Running The Application