GPIO Polling

This example application demonstrate how to poll the switch input, and indicate the switch status using the LED.

Description

This application uses the GPIO Peripheral library to read the GPIO pin connected to the switch, and drives the GPIO pin connected to the LED to indicate the switch status. The LED is turned ON when the switch is pressed and turned OFF when the switch is released.

Downloading and building the application

To clone or download this application from Github, go to the main page of this repository and then click Clone button to clone this repository or download as zip file. This content can also be downloaded using content manager by following these instructions.

Path of the application within the repository is apps/gpio/gpio_led_on_off_polling/firmware .

To build the application, refer to the following table and open the project using its IDE.

Setting up the hardware

The following table shows the target hardware for the application projects.

Setting up PIC32MK GP Development Kit

• Connect the Debug USB port on the board to the computer using a micro USB cable

Setting up PIC32MK MCJ Curiosity Pro Board

• Connect the Debug USB port (J1) on the board to the computer using a micro USB cable

Setting up PIC32MK MCM Curiosity Pro Board

• Connect the Debug USB port (J500) on the board to the computer using a micro USB cable

Setting up PIC32MK MCA Curiosity Pro Board

• Connect the Debug USB port (J1) on the board to the computer using a micro USB cable

Running the Application

1. Build and program the application project using its IDE
2. LED is turned ON when the switch is pressed and turned OFF when the switch is released

Following table provides LED names:

---