1.2.1 How the I2C Bootloader library works

The CAN Bootloader firmware communicates with the embedded host device by using a predefined communication protocol.

The I2C Bootloader works in two different modes

Basic Mode

• This mode is supported for all the devices

• Resides from

  • The starting location of the flash memory region for CORTEX-M based MCUs

• The Bootloader performs flash erase/program/verify operations with the binary sent from host while in the firmware upgrade mode

  • The binary sent is only of the application to be programmed

  • Bootloader always performs flash operation from the address for (bootloader or application) binary sent from host

  • The application can use the entire flash memory region starting from the end of bootloader space

• Jumps to the application once verification is completed

Fail Safe Update Mode

• This mode is supported for the devices which have a Dual Bank flash memory

• Resides from the starting location of the flash memory region of both the banks on CORTEX-M based MCUs

• The Bootloader performs flash erase/program/verify operations with the binary sent from host while in the firmware upgrade mode

  • Bootloader can perform flash operation in either of the banks based on the address sent by the host application

  • The application can use only the flash memory region of one bank.

• Performs a bank swap and reset to run the application programmed in opposite bank once verification is completed or a normal reset to run the application in current bank based on command sent from host