legato_quickstart_9x60_cu_tm5000.X
Defining the Architecture
This application demonstrates multi-layer, WVGA graphics using SDRAM memory.
User touch input on the display panel is received thru the PCAP capacitive touch controller, which sends a notification to the Touch Input Driver. The Touch Input Driver reads the touch information over I2C and sends the touch event to the Graphics Library thru the Input System Service.
Demonstration Features
- Legato Graphics Library
- Reference application for the SAM 9x60 Curiosity development board
- 18-bit color, multi-layer, WVGA (800x480) screen design
- Time system service, timer-counter peripheral library and driver
- Graphics Acceleration using integrated display controller (LCDC)
- GFX2D GPU Driver Support
- I2C and touch controller driver
Creating the Project Graph
The Project Graph diagram shows the Harmony components that are included in this application. Lines between components are drawn to satisfy components that depend on a capability that another component provides.
Adding the SAM 9X60 CURIOSITY BSP and Legato Graphics w/ PDA TM5000 Display Graphics Template component into the project graph will automatically add the components needed for a graphics project and resolve their dependencies. It will also configure the pins needed to drive the external peripherals like the display and the touch controller.
Building the Application
The parent directory for this application is gfx/apps/legato_quickstart. To build this application, use MPLAB X IDE to open the gfx/apps/legato_quickstart/firmware/legato_qs_9x60_cu_tm5000.X project folder and press F11. A successful build will generate a harmony.bin file in dist\lcdc_rgba8888_mxt_9x60_cu_wqvga\production in the project folder.
The following table lists configuration properties:
| Project Name | BSP Used | Graphics Template Used | Description |
|---|---|---|---|
| legato_qs_9x60_cu_tm5000.X | SAM 9X60 CURIOSITY BSP | Legato Graphics w/ PDA TM5000 Display | SAM 9x60 Curiosity deve1opment board with RGBA8888 GFX Interface and 5” WVGA PCAP Touch display |
**_NOTE:_** This application may contain custom code that is marked by the comments // START OF CUSTOM CODE … and // END OF CUSTOM CODE. When using the MPLAB Harmony Configurator to regenerate the application code, use the “ALL” merging strategy and do not remove or replace the custom code.
Configuring the Hardware
Configure the hardware as follows:
- Connect the ribbon cable from the display to the J13 connector of the SAM 9x60 Curiosity Development Board.
-
Take an SD Card formatted with FAT32 file system, and copy the boot.bin binary file from this location. Also copy the harmony.bin file you generated from the “Building the Application” section.
-
Insert the SD card to J3 of the SAM 9X60 Curiosity development board and power up the board by connecting the powered USB cable to the USB port J1 on the SAM 9x60 curiosity development board.
Running the Demonstration
When power-on is successful, the demonstration will display a similar menu to that shown in the following figure (different configurations may have slight variation in the screen aspect ratio):
