Building and Running the SDCARD Bootloader applications

Downloading and building the application

To clone or download this application from Github,go to the main page of this repository and then click Clone button to clone this repo or download as zip file. This content can also be download using content manager by following these instructions

Path of the application within the repository is apps/sdcard_bootloader/

To build the application, refer to the following table and open the project using its IDE.

Bootloader Application

Test Application

Setting up SAM E54 Xplained Pro Evaluation Kit

• Connect the Debug USB port on the board to the computer using a micro USB cable
• Use the sdcard slot at the bottom of the device to insert a sdcard

Running the Application

1. Open the test application project test_app/firmware/sam_e54_xpro.X in the IDE
2. Build the project to generate the binary (Do not program the binary)
3. Open the bootloader project bootloader/firmware/sam_e54_xpro.X in the IDE

4. Build and program the application using the IDE

5. LED0 will be Turned On once programming is completed and bootloader starts running

6. Open the Terminal application (Ex.:Tera Term) on the computer to get test application messages through UART once bootloaded
7. Configure the serial port settings as follows:
   • Baud : 115200
   • Data : 8 Bits
   • Parity : None
   • Stop : 1 Bit
   • Flow Control : None
8. Copy the generated application binary file to a sdcard from the Host PC
   • <harmony3_path>/bootloader_apps_sdcard/apps/sdcard_bootloader/test_app/firmware/sam_e54_xpro.X/dist/sam_e54_xpro/production/sam_e54_xpro.X.production.bin

9. Rename the copied application binary file to image.bin

10. Insert the sdcard with the application binary image.bin to the sdcard slot on the device

11. Once the application is successfully programmed LED0 should start blinking and you should see below output on the console

    

12. Remove the sdcard from the sdcard slot

13. Press and hold the Switch SW0 to trigger Bootloader from test application and you should see below output

    

14. Repeat Steps 10-12 once and jump to Step-15
    • This step is to verify that bootloader is running after triggering bootloader from test application in Step 13
15. Press and hold the Switch SW0 and then press Reset button or Power cycle the device to force trigger bootloader at startup
16. Repeat Steps 10-12 once
    • This step is to verify whether bootloader is triggered by switch press at reset

Additional Steps (Optional)

• To bootload any other application refer to Application Configurations

• Once done repeat the applicable steps mentioned in Running The Application

---